Curious about how SolveTech’s technology would measure the thickness and variability of your material?
Send us a sample, and we will measure your material per ASTM Standard D8136 if applicable. This allows you to see the performance of the PR2000 or our other equipment on your material. If requested, we will also provide you with a video of the test.
We offer free sample testing to those considering purchasing our equipment, and we also offer thickness variability testing as a paid service. Sample testing is often the first step in evaluating a film application.
Please fill out the form below to request a samples test, or email us at info@gauging.com or call 302-798-5400.
Our test reports will describe the device, your samples, the calibration procedure and the performance of the instrument on your material.
For a sample analysis report like the one in the link above, please send your sample to:
SolveTech, Inc.
1711 Philadelphia Pike
Wilmington, DE 19809
USA
* SAMPLE PREPARATION INSTRUCTIONS ARE AS FOLLOWS:
- Cut sample material at least 3.5” wide off the end of a roll.
- Please mark sample(s) with a reference ID number. A permanent marker works fine.
- When packaging for shipment, make sure that material is protected from getting crushed or creased.
We will run your sample in our PR2000 and produce a thickness profile like the one shown below. We will also create a video of us running your material.
Our analysis of your sample will allow you to see a thickness profile across the strip of material. Any non-conductive material can be tested. Contact us today to discuss your needs at info@gauging.com
Thickness Gauging Sample Test | Test Plastic Film Thickness | Measure a Plastic Film Sample | Test Thickness Gauging Technology
SolveTech, Inc